Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

quick 2-part grinder wheel question

Posts

quick 2-part grinder wheel question

#1

quick 2-part grinder wheel question

Ted

>I just purchased a 6"x1" white Norton wheel from Lee Valley and it arrived with bushings that are only 5/8" wide. Is this normal, or should they be closer to 1" wide? Is this a big deal or not?

Secondly, when you dress a wheel, do you keep the corners square or round them over a bit?

Thanks,

Ted

Re: quick 2-part grinder wheel question

#2

Re: quick 2-part grinder wheel question

Russ Babbitt

>I am not sure how bushings are shipped but I would like to see 1" bushings. I dress my wheels square but have seen others intentionaly round off their edges. I have seen them do this to sharpen the small hollowing cutters on the edge of the wheel.

Re: quick 2-part grinder wheel question

#3

Re: quick 2-part grinder wheel question

Bill Howatt

>The grinding wheel is held vertically true by the 2 large washers on either side and they also transfer the turning torque from the shaft to the wheel. The bushings only center the wheel hole on the shaft and 5/8 should be plenty to do this.

Bill