Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

can I slow down the warping?

Posts

can I slow down the warping?

#1

Steve Kubien

can I slow down the warping?

Steve Kubien

>Hi folks,

Today I was having a go at some wet ash, making a NE bowl/vase/thingie. When I started hollowing it out, all was well. By the time I got done the rim had warped so much that final finishing cuts resulted in one side being slightly thicker than the other. How do I avoid this in the future?

I should point out that I am working on a 1/2hp mini lathe so I cannot really hog out a ton of waste very quickly. Slow and steady for this newbie.

Thanks,

Steve Kubien

P.S. I'll try to post a picture later tonight. Other than the funky rim, I'm really happy with how it came out.

Re: can I slow down the warping?

#2

Keep it wet...

Peter Teubel

>Use a spray bottle to keep it moist until you are finished cutting.

Re: can I slow down the warping?

#3

Re: can I slow down the warping?

Bob Fawcett

>Steve,

David Ellsworth on one of his videos, showed a technique where he would cut the outermost portion of the bowl to finish cut, then proceed toward the center. He would leave the inner part quote a bit thicker to give it good strenght. Looked like he did about 1" at a time.

Re: can I slow down the warping?

#4

Re: What Peter said.

Allen Neighbors

>I turn a lot of wet wood to finish. I sometimes spray the outside of a bowl 5 or 6 times while I'm turning the inside. My bowl steady gets a lot of soap solution (I have a 409 bottle filled with the solution, which I rub on after I spray it. Sudses it up a lot, and doesn't dry out quite as fast).

It does slow down the warping. I started doing this when I was turning on Old Griz (1/2 hp).

Re: can I slow down the warping?

#5

Re: can I slow down the warping?

Leppikallio

>One way to cure this problem is to finish it to final thickness about 3/4" or 1" deep and then move on. Don't go back to finished area.

However wet wood in should be quite fast to cut. If you have drilled center hole to final depth it shouldn't take many cuts to hollow bowl on that size (what I think it would be in lathe with 1/2" HP motor). I have one of those minis also but once I learned it limits it can do its job quite well.