Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

wood star assembly

Posts

wood star assembly

#1

wood star assembly

bhenr99

>I seen a peppermill that had like a star formation in the center. To do this I know that you have to rout Vs in the wood and then put wood into the V of a different color. I'm trying to find out how to rout and assemble the center star section of a peppermill displayed on this site in the peppermill contest entries #429 on page 3 of the entries. Thanks for any help.

Bob

Re: wood star assembly

#2

Re: wood star assembly

john lucas

>Bob There are several ways to do it. I'd have to look up the angle but one way is to cut 4 sided "diamonds with 60 degrees on 2 sides and 120 on the other two. Then assemble these into the star and fill in the gaps with 60 degree triangles.

I have done it routing 90 degree rabbits in all 4 corners and then using a 90 degree V bit to cut a notch inbetween the corners. I filled the 90 V notch with a square piece of wood and then planed it flush. You have to figure the cuts pretty accurately.

One of my segmented books has instructions on how to make the diamonds and I believe it was Wood Turning Design that had an article by Eli Avisara on how he does his stars.

Re: wood star assembly

#3

Re: wood star assembly

Joe Herrmann

>Yes, it was issue #4, Winter, 2005 that had the description of how Eli made his stars.

Joe

Re: wood star assembly

#4

Re: wood star assembly

john lucas

>Thanks Joe. I just found it myself and was going to post it.

Re: wood star assembly

#5

Re: wood star assembly

john lucas

>The other star article is Stickwork for use in Woodturning by Dick Bew. It is in The Best of "Woodturning" magazine Woodturning Techniques.