Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Hint:: Sanding nubs

Posts

Hint:: Sanding nubs

#1

Hint:: Sanding nubs

Allen Neighbors

>This is the easiest way I've found to sand off the nubs after I've finished the bottom of a bowl.

This is a scrap piece Jam Chuck I use sometimes for the opening in vases. I added some Velcro Hook to the flattened end, and cut three circles from one of Vince's 3" discs, of each grit.


img

Re: Hint:: Sanding nubs

#2

Re: Hint:: Sanding nubs

Barry Irby

>Allen,

I like your sander, but what I do is just chuck one of my regualr sanding discs in a Jacobs chuck in the lathe or in the drill press. In the DP, you cna jsut lay the bowl on the tabel of the DP and bring the quil down lightly and sand the bottom. Of course, this assumes you have a DP. I also use it for sanding "of the lathe". I lower the table and block the quill "down" and sand away.

Re: Hint:: Sanding nubs

#3

Re: Hint:: Sanding nubs

john lucas

>I do that also. I also have a 1/4" handpiece for my Foredom flex shaft machine. I have sanding discs down to 1". Very handy for sanding the bottom of small things like boxes.

Re: Hint:: Sanding nubs

#4

Re: Hint:: Sanding nubs

Mike Rubes, Apex, NC

>Thanks, guys! Those are great ideas. I love the solutions that are really simple and in front of your face the whole time! I've been carving and handsanding the nubs off the bottoms of some of my bowls with less than stellar results :)

Great stuff!

Mike

Peeking at the forest through the trees in Apex, NC!

Re: Hint:: Sanding nubs

#5

Great idea Allen!!

keith zimmerman, Normal IL

>

Re: Hint:: Sanding nubs

#6

Re: Hint:: Sanding nubs *LINK*

Darrell Feltmate

>Allen:

Very nice.

I do something similar with my bowl lathe and a dedicated holder for #M Roll-Loc discs. There is a picture at the bottom of the link.


Around the woods: Sanding Pad