Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Top Screw Vice?

Posts

Top Screw Vice?

#1

Top Screw Vice?

MikefromTn.

>For lack of the proper name, Has anyone seen any plans for a top screw vice? I've seen a few jigs made with pipe clamps, but would like to make a more permiment one for segmenting.

Re: Top Screw Vice?

#2

Re: Top Screw Vice?

Bill Crommett

>I made mine with a bench vice screw from Highland Hardware, but this is far too overdone and if you can find a less beefy one, you could save some money.

Re: Top Screw Vice?

#3

Pics, we want pics, we want pics, we want pics, we

Don Henthorn

>

Re: Top Screw Vice?

#4

Lighter screw

Dave Staeheli

>I've made a top screw vise with a screw from Woodcraft that I think was for making a veneer clamp. I admit my vise is pretty beefy, made from salvaged iron I had laying around. The top and bottom cross pieces are made from 6" channel, the side posts are made from road sign posts. You know the kind, the square tubing kind with holes every two inches. I welded two up right posts on either end of the bottom cross piece, then welded to the top cross piece the side posts that were the next size down of square tubing sign post. That way they slipped inside of the bottom side posts. The a couple of bolts are pushed through the corresponding holes of the side posts, so I have a very ajustable hight. The side posts are 16 inches apart, inside to inside, so what ever fits between them also fits on my lathe. I can clamp anything from a foot hight to maybe three feet high.