Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Blount Lathe Question

Posts

Blount Lathe Question

#1

Blount Lathe Question

C.W.Stivison

>My neighbor has an old blount lathe that he is willing to part with but of course it has a 5hp 3 phase motor and of course I don't have 3 phase power availble. Is there any resonable way to convert it to 220 single phase? (New motor, pulley system of some sort.) The price is reasonable if it dosen't cost to much to convert.

Thanks in advance.

CW

Re: Blount Lathe Question

#2

Re: Blount Lathe Question

Randy Privett in IN.

>CW,

You could buy a phase convertor, they are on sale at Enco.

http://www.use-enco.com/CGI/INSRIT?PMAKA=297-3725&PMPXNO=952748&PARTPG=INLMK3

It's not really 3 Phase but it will work. You'll lose about 25% of your HP.

Randy

Re: Blount Lathe Question

#3

Re: Blount Lathe Question

Brian McInturff in SC

>MSC direct has them on sale right now also. I think for a 5hp converter it's around 150.00 I got the sales brochure in the mail the other day.

Brian

Re: Blount Lathe Question

#4

Re: Blount Lathe Question *LINK*

Bob Fawcett

>You could also use an inverter drive variable speed controller. This would give you variable speed and 3 phase.

The motor on my Powermatic and a lot of others with variable speed is 3 phase. The inverter drive makes 3 phase out of single phase, and allows for variable frequency. This is what gives the variable speed. You need to know what the speed of the motor is to determine the range of speeds you would get from the controller.

My motor plate shows it is a 1720 rpm motor so this is the native speed with normal 60hz input. The controller shows a frequency range of 1-400hz. This allows me to get from almost 0 to 3200 rpm. The belt drive on high speed pulleys looks like there is still a small reduction to the headstock, so the motor is turning faster.

One of the ones at the link below may work.


VSdrives

Re: Blount Lathe Question

#5

Absolutely agree, depending...

Gary Evans Tallassee, TN

>on your budget. If $200 to 400 is not excessive, then the VFR drive is the way to go. You could probably buy an adequate singe phase motor for the lower end of the scale. I'm not familiar with the Blount lathe, but I have difficulty imaginging a 5 HP lathe.

Are you supposed to hold the tools yourself? 8^]

Gary

Re: Blount Lathe Question

#6

I had an old Blount lathe on an engine lathe

Don Henthorn

>cchasis that came out of Mission High School in San Francisco many years ago. The motor mount would have held an elephant but the motor was gone. I installed a Sears 3/4 hp motor that I ran on 120 and it had all the power I needed for that lathe. Here is a pic:


Re: Blount Lathe Question

#7

Re: Blount Lathe Question

C.W.Stivison

>This lathe has the face plate on the end of the motor shaft. It came from a cabinet factory.

Thanks

CW