Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Cracking Roughouts... Bad!

Posts

Cracking Roughouts... Bad!

#1

Cracking Roughouts... Bad!

Allen Neighbors

>Not long ago, I posted a question about roughing out bowls. I had many good suggestions, which I printed out for my shop notebook.

I went at it full bore.

I turned several roughouts... from 10" to 18" dia... from Sweet Gum, Apricot, Honey Locust, English Walnut. I kept notes of everything I was doing.

Several roughs of SweetGum and Apricot were roughed to 10% thickness, with the lower bowl, and bottom slightly thinner. I coated some with slathered on (2 coats) Johnson's Paste Wax, and some with a heavy coat of Anchor Seal, inside and out.

I decided to check them out today, and all but two of them have cracked. not just one or two little cracks, but several cracks that have opened up as wide as 1/16" and as much as 3" to 4" long.

The bowls were all stored on open wire shelves in my shop, which is unheated. The temperature has never been above 60degrees F in there, but has been below freezing much of the time (until this last week). I also did several roughs that I put in the soap solution, which is my normal procedure. Those are still alright.

This is the pits!

From now on, if I don't put 'em in the soup, I'll bag every one of them after the anchor seal sets.

Re: Cracking Roughouts... Bad!

#2

Re: Cracking Roughouts... Bad!

R THOMAS

>Allan,sweet gum is bad to crack as the sap wood and heart wood will not dry at the same rate also when temps are near or below freezing the air is very dry. Here in Florida the air is very damp even in the winter. I use anchor seal on my bowls inside and out I lose very few. hope this helps R Thomas

Re: Cracking Roughouts... Bad!

#3

Re: Cracking Roughouts... Bad!

Bob Fawcett

>Sorry to hear about your cracking problem.

Keep making soup.

Re: Cracking Roughouts... Bad!

#4

Re: Cracking Roughouts... Bad!

georgetroy

>I turn my wood green and don't worry about cracking. Small diameter is end grain turning and flat grain is natural edge. My dry bowls is segmented turning that I can turn thick or thin. Works for me the last 20 years. GT

Re: Cracking Roughouts... Bad!

#5

Re: Cracking Roughouts... Bad!

robo hippy

>Freezing temperatures make it very dry, and that could have contributed to the cracking. Higher humidity slows down the drying. I seldom get freezing here in western Oregon, mostly rain, and my shop humidity is at 65%, even with a small heater. I do use the soap, but (along with DNA) haven't noticed any difference in success rates for drying blanks. Mostly it is getting a micro environment for drying, either by bagging, burying in wood shavings, or setting it on a shelf. If you are returning the blanks when dry the LDD won't make any difference in sanding, but if you turn to final thickness, soak, then dry, sanding is a lot easier.

robo hippy