Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

VicMarc controller question

Posts

VicMarc controller question

#1

VicMarc controller question

Doug Smith

>We have a 1997 VicMarc VL300 24" swing lathe.

It has a 1.5 hp motor and acts about like a 3/4 hp motor. We removed the motor and had it checked at an electric motor shop and it got a good to go. What's next"

Is there a place to have the controller checked and or adjusted?

Suggestions anyone?

Thank You

DougSmith

Re: VicMarc controller question

#2

Re: VicMarc controller question

Russ Babbitt

>I would start with Craft Supply. They are a vendor of Vicmarc. If it was sold by them they probably supplied the controller. The controller may be a Minarik....check with the manufacturer.

Re: VicMarc controller question

#3

Re: VicMarc controller question

Mike Cunningham (Cape May NJ)

>I agree with Russ. If the lathe started out from CS then call them. Roger Durst is their head lathe tech and extremely accomodating and helpful. You can reach him at: 1-800-398-2743.

If it's an Aussie version, email Vicmarc.

Re: VicMarc controller question

#4

Re: VicMarc controller question

Doug Smith

>Russ and Mike;

Thank you for your response. It did come from Craft Supplies. I will contact Roger.

Doug Smith

McMinnville, OR

Re: VicMarc controller question

#5

Re: VicMarc controller question

Bill Hale / Woodspinner

>Doug

If is a DC motor remember that torque diminishes with lower RPM. Change the pulleys so you can run the motor at high speed and see if that helps.

This is why people are willing to pay the high price for AC motors. AC motors hold torque much better at low RPM.

Bill in Casa Grande AZ.