Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Coolibah Burl

Posts

Coolibah Burl

#1

Coolibah Burl

Mike Cunningham (Cape May NJ)

>Coolibah burl natural edge bowl. 17" overall with 9" bowl area, height 3" Sanded through 600. 3 coats Watco and Beall buffed.

Thanks for looking

Mike


img

Re: Coolibah Burl

#2

Re: Coolibah Burl

Ruth Niles

>Cool, Mike, I really like this. Is the color as red as it appears? It's beautiful.

Re: Coolibah Burl

#3

Re: Coolibah Burl

Mike Cunningham (Cape May NJ)

>Thank you Ruth. Yes, several shades of red as well as some near yellow. The stuff is hard as concrete, numerous trips to the grinder.

Thanks again

Mike

Re: Coolibah Burl

#4

Re: Coolibah Burl

Tommy Holmes

>Beautiful piece Mike. Did you do anything to the bottom? I have just bought a blank like this (smaller) recently from Woodturningz and didn't quite know what to do with the bottom. It is covered with with a heavy coat of wax.

Re: Coolibah Burl

#5

Re: Coolibah Burl

Mike Cunningham (Cape May NJ)

>Tommy,

I turned the bottom as you would with any bowl. This was a burl cap. I mounted it smooth side with a face plate and turned the bottom (this side had the points or eyes) leaving it a bit thick to allow flattening and turning of the top. Finished the bottom and then turned it around and hollowed out the bowl and turned down the wing areas. When finished I actually put it back on the lathe holding it with a vacuum chuck to touch up a few spots on the bottom, though normally it would have been done at this point. In this photo you can see the bottom though I admit it's a poor photo, in the center are the usual "rings" that I and many use to finish it off.

Hope this helps

Mike


img

Re: Coolibah Burl

#6

Re: Coolibah Burl

Tommy Holmes

>Thanks for the picture of the bottom and explanation of how you turned it. This is one more step towards working up the courage to try mine.

Re: Coolibah Burl

#7

Re: Coolibah Burl *LINK*

Mike Cunningham (Cape May NJ)

>Tommy,

No problem, they're easy to do, just give it some thought and take your time. Some of these burls, particularly the Australian, at least in my opinion are quite hard, contain silica and take a toll on tool edges. Keep the tool sharp, you can't make too many trips to the grinder!

I buy my Aussie burls from LeeTreeworks. Hit the link for a tutorial on turning caps, I think it will help you.

Mike


How to turn a burl cap

Re: Coolibah Burl

#8

Re: Coolibah Burl

Bob Fawcett

>Very nice wood.

I may have to try one of these someday.

Thanks for the link also.

Looks like you have been busy, unlike me who has been busy with too darn much work.

Re: Coolibah Burl

#9

Re: Coolibah Burl

Tommy Holmes

>Mike, this link is just what I needed. I will be turning a burl cap shortly. I really appreciate the information.