Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Sawing and drying beech

Posts

Sawing and drying beech

#1

Sawing and drying beech

Paul in NJ

>I know this is the Turning board but I thought some of you might have experience with beech. I might have the opportunity to have some beech custom sawn for wooden plane stock. Anyone have suggestions on how to cut for optimum yield? I am thinking of 5/4 and 8/4 quarter sawn with some 16/4 either quarter or completetly flat sawn (re-saw later to quarter). I need true quarter sawn stock to properly build planes. I understand beech may twist and cup a lot when drying. Is there an optimum length for drying efficiently and minimizing loss to end checks? Most of my planes will be 12" or less in length with a few up to 30" or so. I plan to coat the ends, sticker, and cover the pile for air drying.

Paul Dzioba

Re: Sawing and drying beech

#2

Re: Sawing and drying beech

Barbara Gill, Remlik VA

>Paul, I have sawn quite a bit of Beech. In fact the last time was for planes. Probably the best way would be for me to talk to you. I do a lot of quartersawing. Send me an e-mail and we can arrange for a time to talk.

Re: Sawing and drying beech

#3

Re: Sawing and drying beech

Bill Neddow

>Paul, I am not sure about using Beech for planes. I made some serving trays years ago -- a beautiful beech board as the center, in a frame of contrasting wood (like Walnut or Purpleheart). The frame was kind of a Chinese design with two vertical side pieces coming to the ends where a horizontal piece served as a handle. The frame was larger than the Beech board and held to it by dowels. The damn Beech never stopped moving and I think almost every one of these pieces failed. Don't think you want planes that change their dimensions every time it rains!