Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

liming alternative?

Posts

liming alternative?

#1

liming alternative?

dwfII

>I want to lime this piece I am working on. Is there an alternative to spending $20.00 plus shipping on liming wax? I noticed another fellow used india ink instead of black patinating wax.

Has anyone tried mixing powdered milk paint with oil? wax? water?

Any suggestionbs would be welcome...

thanks

DW

In the High Desert of Central Oregon

Re: liming alternative?

#2

Re: liming alternative?

John Lucas

>I've used shoe polish. You can dilute it with mineral spirits if necessary or you can apply it, wipe it off and then use mineral spirits to wipe off more if necessary. I seal it with a wipe on coat of shellac before applying any finish.

Re: liming alternative?

#3

Re: liming alternative?

Clay Foster

>Spackle colored with acrylic paint will work. It may need to be thinned a little with water, depending on the size of pores you're trying to fill. Rub it on, then wipe off excess with a damp paper towel.

For really coarse grain, I use tile grout. It can be colored with acrylic paint also.

Re: liming alternative?

#4

Re: liming alternative?

John Lucas

>spackle is what I've been using to fill the morter in the Brick pieces that I've been turning lately. To keep it from filling all the wood pores and just the morter joints I had to spray lacquer on the wood.

Re: liming alternative?

#5

Re: liming alternative?

Ralph Watts

>DW,

If you are looking for black grain filler, I have used constantine's Paste wood filler with good success. It comes in a variety of colors. It will stain bare wood so best to give your piece a couple of coats of poly or something to keep the filler from staining (unless that is what you want). You can also use Golden acrylics (modeling paste) tinted with any color you choose. Put it on by rubbing it in to the pores. After it dries, it must then be sanded to remove the excess but leaves a great surface. It may take a couple of coats because the acrylics will shrink some. Or if the piece is still on the lathe, turn or sand off the excess.

Ralph

Re: liming alternative?

#6

Re: liming alternative?

John H. Williams

>I have used artist's oil colors mixed with Miniwax poly. Mix in a separate container. Sand to remove all scratches, then apply with a paper towel with the lathe turning at a comfortable speed. Keep applying until the desired effect is achieved. The poly oil hastens drying and pressure creates some heat which helps the drying along too.

Re: liming alternative?

#7

Re: liming alternative?

E.T.

>With this product, "a little goes a long way". If you are using it on turnings only, a can will last for years, or even outlast your interest in the novel color and texture effects. It really takes very little to fill the pores of a HF or bowl. I am still using a can I purchased over 10 years ago. Although, I don't use the stuff all the time.

If you want to apply it to furniture or cupboards I could see a can or two diappearing very quickly.