Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

DC Motor Question??

Posts

DC Motor Question??

#1

DC Motor Question??

Jimiles-Charlotte, NC

>Anyone know about DC motors? I recently got a Leeson DC motor,1800 rpm, type 280-14, ( runs on 110 volt) with a Dart 250 Controller. It seems to run and the controller will adjust the speed. However it has no torque, I can stop the motor with my hand. Any idea where to start to determine what is wrong or worth fixing? Thanks for any advice!

Re: DC Motor Question??

#2

Re: DC Motor Question??

Russ Babbitt

>What is the HP rating?

Re: DC Motor Question??

#3

Re: DC Motor Question??

Russ Babbitt

>Also need to know the volt rating on the motor. Probably 90vdc. The controller may run on 110vac but it changes to dc.

Re: DC Motor Question??

#4

Re: DC Motor Question??

Jimiles-Charlotte, NC

>Russ:

90 volt DC, I see no HP listed on it, unless FF 1.40 means something.

Re: DC Motor Question??

#5

Re: DC Motor Question??

Jim Swank

>There would normally be a HP rating on it, and probably an FLA (Full Load Amps. Does it have 2 wires or 4?

Re: DC Motor Question??

#6

Re: DC Motor Question??

Jeff Myroup

>Jim,

It sounds to me that you may have a problem with one of the fields. A problem in either the series or shunt field can cause low starting torque. Since you have no load on the motor when you started, it will start but when you put a load on with your hand it stops. I would recommend you take it to a motor shop. They can do a full test and re-wind the motor if needed. It is normally alot cheaper than buying new. They will also change the bearings if needed. The horse power rating is a figure of speed and torque. You should not be able to stop the motor with your hand. I am assuming it is a big motor for a lathe. The problem could be in the controller, but I tend to think it might be the windings. It is hard to tell with out seeing the set up.

Jeff

Re: DC Motor Question??

#7

Re: DC Motor Question??

Bill Hale / The Wood Spinner

>If you got it from a dealer talk to them.

Remember that a DC motor has very little power ( torque ) at low speed. I believe most DC motor lathes have a pulley system to allow running the motor at a higher RPM.

Bill in Casa Grande, AZ.

Re: DC Motor Question??

#8

Re: DC Motor Question??

Jeff Myroup

>Starting torque and speed vary greatly in DC motors depending on the type of DC motor it is: Shunt wound motors have a very good linear starting torque, where series wound have low starting torque. Cumulative and differential wound motors have close to the same starting torque as shunt wound, but drop off a little near top speed.

Re: DC Motor Question??

#9

Thanks for advice!

Jimiles-Charlotte, NC

>