Captured Hollowing has a new Convert - long
Mark Kauder, Phenix City, AL
>First off, thank you to Bob Moffett for reminding me of Bruce Hoover's article in the Spring 2003 issue of the AAW Journal. That design fit the bill exactly.
Last year at the Anderson Ranch, Art Liestman was nice enough to loan me his Jamieson captured hollowing rig (with Kelton Hollowing tools). I liked it so much, I ordered the tools that day. Later in the year, I built the tool support out of plywood, as shown in the instruction with the Jamieson capture rig, but was not sure abou how I was going to mount it, since even with the bed extension on my lathe, it was too short. Then when I extended my shop, the placement of my rolling turning tool chest/ Grinder bench, suggested to me that placing the tool support on that, would be just about perfect. But, I was not working on anything at that point, so I had no chance to try it.
Then during the last 8 weeks, I started working on a new series of hollow forms. Now, sometime I build my hollow forms in two pieces (and segmented stuff is already mostly hollow anyway) but mostly I do them whole, and then final hollowing after the outside shape has been determined.
Well, three times during the last month, while finishing the upper half of a HF, I caught my little swan neck in the mouth and broke the top. One really good thing about segmenting, is that this does not necessarily mean it is gone - I just rebuilt the tops. However, it got me thinking about the hollowing rig again, and especally the laser holder/adjuster I bought from Donald Derry. I thought about the laser when after successfully hollowing one HF, and then putting my thumb through the top. The hole was too small to measure through - it felt good, but obviously was not. Rebuild time.
So today, I finished all the details on the Laser Holder attachment, found the bushing I needed to use my little Sorby Swan Neck, etc, etc.
Well, I just got done finishing up the neck of this one. Smooth as Glass, and without that little knot in my stomach the whole time.
I always enjoyed the challenge of hollowing, liked my Pencil arm brace system, many times reverted to my old Sorby Hollow Master with a straight handle for final finishing. But all of it was always done with the knot in the stomach. This is great.
Thank you all for the help.
Mark
