Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Why a Copper Nail in Homemade burner???

Posts

Why a Copper Nail in Homemade burner???

#1

Why a Copper Nail in Homemade burner???

Greg in Oshkosh

>I'm trying to make a custom woodburning tip like the ones described in the Pyrography article by Molly Winton in the articles section. Got some NiCr wire but am having problems with the copper nails. Why use copper and not brass or copper plated steel? I know that copper is the second most conductive element and that silver (the most conductive)nails are reserved for vampires. My homecenter now carries plated nails for use with copper plumbing supplies and the only other copper nails I can find are very small.

So why copper? Is it just for conductivity?

Re: Why a Copper Nail in Homemade burner???

#2

Re: Why a Copper Nail in Homemade burner???

Gary in Zirconia, NC

>Yes, it's conductivity. You can find the copper nails at a marine supplier. They are used in building boats.

Re: Why a Copper Nail in Homemade burner???

#3

Steve Kubien

Re: Why a Copper Nail in Homemade burner??? *LINK*

Steve Kubien

>No idea "why" but here's where you can find 'em...if not locally.

Cheers,

Steve Kubien

Ajax, Ontario


copper nails

Re: Why a Copper Nail in Homemade burner???

#4

Dick Hines

Re: Why a Copper Nail in Homemade burner???

Dick Hines

>I picked up a box of copper nails at Lowe's.

Re: Why a Copper Nail in Homemade burner???

#5

Re: Why a Copper Nail in Homemade burner??? *LINK*

Molly Winton

>Looks like you've already got the information you were looking for, but I've got another link you may want to try out for the nails. I think they're a little cheaper.


http://www.jamestowndistributors.com

Re: Why a Copper Nail in Homemade burner???

#6

Forgot: do a search for copper nails

Molly Winton

>

Re: Why a Copper Nail in Homemade burner???

#7

Re: Why a Copper Nail in Homemade burner???

Pascal Oudet

>I also couldn't find big copper nails. I tried with brass screws, or even small rods (6mm, 1/4"). I can turn the rod to a smaller diameter for where the wire is wound around, and keep end full size for the "head".

just one word of caution: brass, and copper, are electrically conductive, and better than Nichrome. so when you wind your nichrome wire around the copper, it basically acts as a short circuit between the loops. make sure your burner is powerful enough, it will draw some amps. (I tried insulating with polyimide, a material which can withstand a high temperature, but it's too hot). you will probably also have a greater thermal inerty than what you are used to with the wire patterns

Pascal