Re: HF
Mark Mandell - Gone Round In Jersey
>Thad,
I had one of those HF things, and, after completely rebuilding the chain-holder, I was able to get "reasonal" performance out of it until the switch went bad. It was not, however, what I'd call a precise piece of work, and it was very hard to get a truly consistent deptch on the teeth, especially when switching sides.
HF informed me that a new switch/circuit board would take 4 months and cost $20. I informed the service person that "I was born at night but not last night," and looked elsewhere.
I settled on a Tecomec chain grinder from Madsens. This changed everything. At $230, it locks the chin at a precise angle and set and grinds both sets of teeth to within a 1000th in uniformity. I can just "kiss" a chain taking a very small amount of metal in about 6 minutes. My chains had never run so smoothly, even when new, with no pulls or bounce, and I can vary the pitch and bevel to suit the wood I'm cutting. I'll post a link to Madsens but their site in down right now.
In my opinion, skip the HF deal; it's not worth the price.
mm
Would