Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Exchange piece heads North tomorrow

Posts

Exchange piece heads North tomorrow

#1

Exchange piece heads North tomorrow

Mark Wollschlager

>A Yorrel burl box headed to the ice cold north.

Mark.


img

Re: Exchange piece heads North tomorrow

#2

Re: Very nice looking!

Ronny Eelen (Belgium)

>

Re: Exchange piece heads North tomorrow

#3

Re: Exchange piece heads North tomorrow

George Van

>Mark, I like the lid! I have saved a piece of burl like this, well not as good of figure as this but a sloped top. How did you chuck the top to hollow and fit?

Re: Exchange piece heads North tomorrow

#4

Re: Exchange piece heads North tomorrow

Mark Wollschlager

>I finished the top by making a fairly deep compression chuck.

The 'chuck' is a hollowed out cylindrical blank with very straight sides.

I cut slots down the sides with a bandsaw and used a hose clamp to tighten the grip.

There was a fairly small section to grip so only about 1/8th" protruded from the chuck.

Getting it back out was 'fun'.

I wanted to reuse the chuck to finish the bottom so I didn't want to destroy it.

Good thing.

I showed the piece to my wife yesterday and her first words were 'I want one just like it'. :-)

Mark.

Re: Exchange piece heads North tomorrow

#5

Re: Exchange piece heads North tomorrow

George Van

>Thanks Mark, very understandable.