Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Turning frozen wood

Posts

Turning frozen wood

#1

Turning frozen wood

Dawn Adams

>I have no more wood left in the shop. I do, however, have a frozen root just outside the door. I want to turn!!! Has anyone ever turned frozen wood? Any comments or suggestions would be appreciated.

Re: Turning frozen wood

#2

Re: Turning frozen wood

Doug Thompson near Cleveland

>Dawn,

Frozen wood turns the same as green except the shavings are cold on the hand. I wear a glove when roughing a blank, the exchange turning was done from frozen wood.

Go for it,

Doug

Re: Turning frozen wood

#3

Re: Turning frozen wood

Ron in Drums PA

>Yup, it was freshly cut too.

Frozen shavings hurt, wear a face shield and gloves (just be careful with the gloves). You might even want to wear a second shirt.

Otherwise it turns wonderfully, maybe even better than green wood that is not frozen.

Re: Turning frozen wood

#4

Re: Turning frozen wood

Dawn Adams

>This frozen chunk is a hickory root (with incredible spalting) and it is turning like concrete. I can only make a few cuts with the gouge and it is dull as a butter knife. Any suggestions? Is hickory root tough to turn?

Re: Turning frozen wood

#5

Re: Turning frozen wood

joaz

>Most roots are tough. Hickory for sure. What's the rush?

Let it thaw and warm up and then try again.

Re: Turning frozen wood

#6

Re: Turning frozen wood

Doug Thompson near Cleveland

>I NEED to say this... You don't have the right tools!

Re: Turning frozen wood

#7

Re: Turning frozen wood

Bill Grumbine (Kutztown PA)

>Dawn, Ijust got home from Woodcraft (Allentown, not Towson) teaching six newbies to turn with frozen wood. It cuts about the same, although if it is wet, it won't start to sling water until it starts to thaw. Hickory is pretty tough, so just keep sharpening, and hoping for spring!

Bill

Re: Turning frozen wood

#8

Brad Vietje

Great for some things

Brad Vietje

>I'm with Ron -- in some ways it can be better than warm green wood. Its especially good for getting a clean cut on a softer, or more difficult wood. Basswood is one example -- sometimes hard to get a good finish off the tool, but turning it frozen can help a lot. That may not help much in Florida or Texas, but up here its easy -- my freezer is 15 acres.

Safe spinning,

Brad Vietje

Newbury, VT

Re: Turning frozen wood

#9

Sawing frozen wood

Barbara Gill, Remlik VA

>I have never turned frozen wood but I have sawn some with my Wood-Mizer. It will dull the tools faster than green. Sharpen frequently. Frozen hickory root can present a number of problems including a really hard wood to start with and possibly dirt. All will dull the tool quickly.