Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Corrugata burl cap

Posts

Corrugata burl cap

#1

Corrugata burl cap

Mike Cunningham (Cape May NJ)

>I've turned a fair amount of Australian burls but this is the first time using corrugata. The piece I'm doing is a burl cap and quite unbalanced and irrecgular, about 23" X 17" X 4", the 22". It's also rather dry.

I'm finding this wood to be harder than woodpecker lips, I mean really hard, beating me up hard.

I'm curious, have any of you turned this stuff and found it to be this hard or have I just hit it lucky? If this is typical, it's my last time.

Thanks,

Mike

ps: I'll post a pic when finished

Re: Corrugata burl cap

#2

Dick Hines

Re: Corrugata burl cap

Dick Hines

>I have turned tow pieces of corrugata and they both were HARD. I talkie to the guy I got it from and he said that is just the way it is. Hard but out standing when finished.

Re: Corrugata burl cap

#3

Re: Corrugata burl cap

Mike Cunningham (Cape May NJ)

>Thanks Dick, this stuff is like concrete and hearing that you've had a similar experience, this is apparently typical. It is beautiful, but so are much softer burls. I think I'll swear off this stuff.

Thanks!

Mike

Re: Corrugata burl cap

#4

Re: Corrugata burl cap

MFoster

>Mike

I'm pretty sure this is one of the many eucalyptus burls from Australia. I turned a burl cap of goldfield burl and had much the same experience. Like turning concrete with many trips to the grinder. I believe many of these eucalyptus burls from AU are from the deserts, so are very slow growing and probably have a lot of silica in them. I find it not too different from turning desert ironwood from the Sonoran desert. They are gorgeous once finished though.

I attended a demo by Stuart Batty a couple years ago at the Totally Turning Symposium. He related a story regarding turning these burls. He found that no matter what tool he used, he was still getting some tearout. (He was working on a series of these, a few of which were the cover for one of the turning supply companies not so long ago). His final solution was to use the negative rake scraper, that many people are now using and touting. I've experimented with a negative rake angle scraper, and have found acceptable results. The down side, as explained by Stuart, is that the bur from grinding is the cutting edge, and is gone in a very short time (especially on these burls). However, it was his finish cut of choice when turning these burls. Hope this helps. Mike

Re: Corrugata burl cap

#5

Re: Corrugata burl cap

Mike Cunningham (Cape May NJ)

>I've been meaning to make a NRS from a spare 1 1/2" wide, thick scraper that was taking up space. This prompted me to do so and it helped considerably. Thanks!

Mike