Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Sharpening Jig - I made this!

Posts

Sharpening Jig - I made this!

#1

Sharpening Jig - I made this!

Joe in a Cleveland suburb

>Hello.

Couple weeks ago I asked about making your own sharpening jig. You all pointed me to several resources. I put all that together and came up with this version. All I did was take scrap pieces of walnut, a couple cherry plywood shorts, and some scrap poplar, glued and screwed it all together and here it is!

I don't really know how to sharpen yet, but it seems to work. I can adjust it in several different ways. Holds the gouge pretty well. Guess it's gonna work. The best part is it's all from scrap that otherwise was headed for the fire pit. It cost about $2 for the rod. That's it.

Thanks for looking. Oh, and feel free to tell me what's wrong with it if there is an obvious reason why it won't work... :)

Joe

Pictures:



Here is the base with the (wrong type grinder and wrong wheel - I know) grinder on it.


Here's a shot of the thingy that holds the gouge. The thumb screw near my palm pushes up a cradle that holds the gouge in tight.


This is the front of it.


Here's another. The eye screw thing tightens down for adjusting the angle. The plans I saw (and web sites) showed making several different blocks with different angled rods and/or they showed bending the rod. I think making it adjustable works fine(?).


This is what it would look like in use.


And another.


That's it.


Re: Sharpening Jig - I made this!

#2

Re: Sharpening Jig - I made this!

john lucas

>Good job Joe. Just goes to prove you don't need a lot of money to make this stuff work. I would recommend making your tool holder (the part that actually holds the tool) shorter. After you grind your tool a few hundred times you won't be able to stick it through far enough to grind it. I made my first one about 2 inches long and eventually made another that was 1 1/2. Now I'm thinking about making a shorter version for the really small gouges like my 1/4" Packard and 3/16 Bonnie Klein.

Re: Sharpening Jig - I made this!

#3

Excellent!

Peter Teubel

>Nice job, Joe! You saved youself a few bucks and I'm sure it will work great. I would suggest you get a good wheel for the grinder, though. The stock gray ones are really only good for lawnmower blades...

Re: Sharpening Jig - I made this!

#4

Re: Sharpening Jig - I made this!

Bob Fawcett

>Looks great Joe.

I made mine too.

Your comment "wrong type grinder". If you mean its a high speed grinder and not a low speed. It will work fine, just get a proper wheel.

Re: Sharpening Jig - I made this!

#5

Re: Sharpening Jig - I made this!

Ron McKinley

>Great photographs Joe! Really sharp and clear and illustrates what you did very well......Ron