Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Sealing End Grain

Posts

Sealing End Grain

#1

Sealing End Grain

C.W.Stivison

>A friend is getting me some chunks of wood and I know the sooner I seal them the better. Do I seal the ends with the checks in them or do I cut them back to the unchecked wood and seal them there. I have a jet mini and can't turn bigger than 10", so do I leave them 24" to 30" long for now or is it better to cut them into 12" chunks and seal those ends. Or would it be best to cut out the pith and seal the halves end grain. I hope this is not to confusing.(My wife says sometimes I can be confusing when I try to explain things.)

Thanks

CW

Re: Sealing End Grain

#2

Re: Sealing End Grain

Bart Rhoads

>If I have wood in log form I will leave it like it is and seal the ends. If checking has started I will cut about an inch off and look and see if the checking is gone and then seal it. Some times there will be checking or cracking that has developed quite a ways up the log and you will end up cutting the log up into 1" circles and never get rid of the cracking. So one or two cuts is all I make and then seal it. Thats the way I do it.

Re: Sealing End Grain

#3

Re: Sealing End Grain

Barry Irby

>I would split the logs length wise along the pith and seal the ends. If you leave them "in the round" they will almost surely split. It helps to just cut a kerf or slot into one side to the pith if you can't cut them all the way in half. Of course, if they are large lags, you can cut them into thirds or quarters to make blanks that will fit your lathe. Sealing the ends slows down the drying but does not stop it. It buys you time and may reduce the spliting somewhat.

If they are large enough, I would take a slab out of the middle to get rid of the pith competley.

Leave them as long (length, not time) as you can. The ends dry faster and thus split, so leave them in long piece and cut them up as you turn them. Rough them into bowl blanks as soon as you can. If you had a ten foot long log and left it full leghth, You might lose five or six inches off each end, The equivalent of one blank out of a dozen, but if you cut it into a dozen blanks first and left them for a while, you might lose all of them.