Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Pith and Bark. Newbie question.

Posts

Pith and Bark. Newbie question.

#1

Pith and Bark. Newbie question.

Joe in a Cleveland suburb

>Hi.

Say "Pith & Bark" 10 times real fast. Sorry. :)

Suppose you were going to use up a bunch of cherry or walnut scraps to play around making your first bowl. These scraps are all from rough sawn lumber and you are going to joint/plane them enough to be able to glue them into one decent size chunk of wood to butcher on the lathe.

I would think you would glue them together so the bark side is all towards the same side, right? Like a green piece of log. Secondly, does the pith side or the bark side end up being the bottom of the bowl? Does it matter?

Thanks,

Joe

Re: Pith and Bark. Newbie question.

#2

Re: Pith and Bark. Newbie question.

john lucas

>Joe it doesn't matter at all. Sometimes I pay attention to the pith vs the bark in order to make the grain flow the way I want in the final piece. If they are still green you could have warping problems, in that case you might want to glue them up so the pith is on the same side in each piece. I haven't tried gluing up green pieces so I don't really know if it would be a problem glueing them up pith to pith and bark to bark. I've done a lot of dry wood glue ups. I would use gorilla glue to glue green wood together.

Re: Pith and Bark. Newbie question.

#3

Re: Pith and Bark. Newbie question.

Ken Grunke from SW WI

>In your case, with the wood you're using it doesn't matter for a couple reasons I can think of:

1. It's kiln-dried wood, and fairly stable

2. Walnut and Cherry are two of the more stable woods because the ratio of tangential shrinkage to the radial shrinkage when drying is closer to 1 than other woods. And the two woods have very similar properties in that regard, so are a good combination together.

But you can run into trouble if you mix grain alignment in one piece--that is, glue one piece with the grain at 90 degrees to the other, for example. Even after wood is kiln-dried, it shrinks and contracts with the seasons so if two glued-together pieces move in different directions, the joint will eventually come apart.