Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Orange trees for turning?

Posts

Orange trees for turning?

#1

Orange trees for turning?

Joe Pack

>Same question as below...

A relative has major orange groves, and usually is in the process of replanting at least some areas, with older trees to dispose of. Is a downed orange tree worth scavanging some wood from to bring from Florida to Ohio?

Re: Orange trees for turning?

#2

Oops...spelling misteak in previous post

Joe Pack

>

Re: Orange trees for turning?

#3

Re: Orange trees for turning?

Bill Turpin in WNC mountains

>Citrus is wonderful to turn. Basically white with hard close grain.

Bill in WNC mountains

Re: Orange trees for turning?

#4

Never turned Orange, Grapefruit is good to turn.

gil jones

>

Re: Orange trees for turning?

#5

Re: Orange trees for turning?

Ken Oakley-Sunny St. Cloud, Fla.

>All the citrus woods are great for turning. I live in Central Florida and have access to groves where I salvage wood from dead trees. Depending of the lenghth of time they have been dead I find the coloring increases spectacularly with time , but splitting increases the longer the tree is dead. Citrus trees are like oversized bushes in that diameters over 12" are not common and the branches are not stright much over 12". If you would like to see pictures of some of the wood, I have listed on Ebay pen blanks I cut from harvested wood. User name-Deltakong. Cypress is a little too grainy for turning in my opinion. If you can while you are down here get a few pieces of Camphor. Turns nice and is very very aromatic when machined.

Re: Orange trees for turning?

#6

Re: Orange trees for turning?

Colin Spencer

>Joe

I can comment on Spanish orange trees, I presume that the Florida ones are similar. Nice wood to turn, you can get a great finish off the tool. It turns better when wet and does not warp or crack very much (unlike most fruit woods). It has little grain pattern, varies in colour from almost white through light yellow to very light orange. It takes stain well. I have never seen any burl's but if they are trimmed the same way as over here you will find that there are some interesting shapes in the trunk near the ground.

Hope this helps

Colin

Re: Orange trees for turning?

#7

Re: Orange trees for turning?

Rick Pixley

>Try getting a root ball..Cut to rough blank and fill the voids with colored epoxy..This can be spectacular..Rick

Re: Orange trees for turning?

#8

Also lots of Pecan farms

Ken Oakley-Sunny St. Cloud, Fla.

>in North Fla. and Georgia.

Re: Orange trees for turning?

#9

Thanks...

Joe Pack

>I appreciate your information. I think I will pick up a bit, and I will definitely look for a root ball. Hope they haven't burned everything by the time I get there.