Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Anybody Want Some Oak?

Posts

Anybody Want Some Oak?

#1

Anybody Want Some Oak?

Raymond Overman in SC

>While I don't usually turn oak, I ran across one that had some interest to it while walking through the woods at my father's place. We hadn't been through them in years and thought we might find something to turn. The oak was a double trunk and all along one of them it had little nodules on the outside. We didn't even take the chainsaw on our walk but decided to go get it and take the tree. Dad's looking at selling the timber next year so we'll probably go back through it to make sure we aren't missing anything. I did see a couple of Hollies and there was plenty of straight Cherry to be had too.

Here is a piece of it that I'll be sending out to my Exchange recipient. The outside edge has some slight burl figure. I hope to have it to them by the first of next week.

White Oak Natural Edge

8 1/2" D x 3 3/4" T

Lacquered


img

Re: Anybody Want Some Oak?

#2

Re: Anybody Want Some Oak?

Bob Fawcett

>Where are you in SC, I am in Savannah.

Remove nospam above for email.

Re: Anybody Want Some Oak?

#3

Re: Anybody Want Some Oak?

Raymond Overman in SC

>Well, maybe a different angle? Did I waste my postage?


img

Re: Anybody Want Some Oak?

#4

Re: Anybody Want Some Oak?

Carole Valentine

>That's a pretty natural edge piece Raymond, but it sure doesn't look like our Oak. I can't see any of the strong grain we usually see. Is it the photo? I am not questioning your identification - I know you know an Oak tree when you see one! LOL It is just unusual looking to me. Looks like ambrosia markings in the bottom.

And you definitely did not waste your postage!!!!

Re: Anybody Want Some Oak?

#5

Re: Anybody Want Some Oak?

Raymond Overman in SC

>Carole,

After finishing it, I asked myself the same question but I'm pretty sure that it is oak. I've been known to be wrong occasionally but since my Papa was with me when we cut it down and he cut BBQ wood in those woods most of his young life, I trust he knows what it was. There's always a chance though.

It was turned wet and thin and allowed to dry. Then I power sanded it through 400 and used BLO to do a final sanding because of problems with the grain. It seemed to fill the problem grain with the slurry created.

Thanks for the comment Carole.

Re: Anybody Want Some Oak?

#6

Leo Van Der Loo

Re: Anybody Want Some Oak?

Leo Van Der Loo

>Hi Raymond, good job on that natural edge bowl, and yes I believe it's Oak, it looks like this probably because it's a burly type of wood, and shows mostly sapwood I think, I would expect the curly grain and figure to show much better in a few months, and the color will get better as time goes by.

Right now the picture doesn't show looks of the wood well in the picture, but I believe given time it'll be a beauty.

Thanks for showing

Leo Van Der Loo

Re: Anybody Want Some Oak?

#7

Brad Vietje

Anybody Would Want That -- Nice Bowl !

Brad Vietje

>