Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

worm tunnels

Posts

worm tunnels

#1

worm tunnels

C.W.Stivison

>I am turning a piece of elm with a few worm tunnels on one side. I have tried to get the dust left by the worm out of the piece, but can't blow it out with air or brush it out. I would like to finsh the bowl with the tunnels left in but I'm afraid the dust will mess up the finish. Any ideas or just make firewood and start over.

Thanks

CW

Re: worm tunnels

#2

Re: worm tunnels

Allen Neighbors

>I get a lot of wormy wood, here in NW Texas. When I want to clean out the worm holes, if a fine air nozzle doesn't work, I dig it out as deep as I can with a homemade "De-Frasser". It's a piece of baling wire, the end has been "spooned" with a small ball pein hammer, then the spoon is filed into a not-so-sharp point. Then I bend a handle in the other end, so I can hang onto it. It works.

HTH

Allen

Cold in NW Texas, expecting more snow... (sigh)

Re: worm tunnels

#3

Re: worm tunnels

Ralph Watts

>CW,

A dental pick works great. If you don't want to mess with digging out the tracks, CA glue the stuff to keep it stabilized. It can then be sanded and finished.

Best regards, Ralph

Re: worm tunnels

#4

Re: worm tunnels

Jorge Castaneda

>You could fill the holes with fine coffe grounds and CA glue.

Re: worm tunnels

#5

Re: worm tunnels

Bart Rhoads

>If you have access to one of those portable home use sandblaster, those work real good. I have used it on mesquite quite a few time. Then you can resand and finish and you will still have the holes. The sandblaster works good on any of your course grain woods. It will eat out the soft grain and leave a real nice texturing effect.

Re: worm tunnels

#6

Re: worm tunnels

Brian Hahn in SW Wisconsin

>If you can't get the frass out with air or a brush, then I'd leave it in. The only problem I've ever had finishing them is that the dust is rather porous and really soaks up the first couple of coats of finish.

Re: worm tunnels

#7

Leo Van Der Loo

I,ve been doing it the hard way, small drill bits,

Leo Van Der Loo

>dental picks, tooth pick, etc, and find that when you have a opening you can blast a lot of the frass out, I don't have a high pressure water jet, but that might be something else to try.

Have fun and take care

Leo Van Der Loo

Re: worm tunnels

#8

Dick Hines

Re: worm tunnels

Dick Hines

>A 100 LBS of comperssed air will take the wrom crap out of the holes. Use a dust mask and face shield.