Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Square lidded padauk box....

Posts

Square lidded padauk box....

#1

Mike Stafford

Square lidded padauk box....

Mike Stafford

>On another forum there was a wonderful turning Challenge and Trade involving boxes and I had to get involved since I just love turning boxes. The rules said the box had to be 3" in height and diameter and have a "turner's fit", i.e. a pop when you opened it. This turned out to be just the challenge for me to try something I had seen pictured in a magazine that was turned by Chris Stott or Ray Key. I think it was really Chris Stott but I am not sure. He had turned a box which had a square lid and the body of the box was round. The grain match between the lid and body of the box was continuous so that was the challenge for me. I managed to get one turned and it has a nice sweet suction fit and a pleasant little pop when it is opened. It certainly was a learning experience. At 3 1/2" tall and 3" in diameter it is turned from padauk. Appreciate all comments and suggestions....


img

Re: Square lidded padauk box....

#2

That is incredible!

Jim Rutten

>

Re: Square lidded padauk box....

#3

Re: Square lidded padauk box....

Jennifer@Indy.USA

>Mike, this is adorable! I love it. You did a fine job on the grain match that's for sure. Somebody is going to be glad you picked their name!

I'm happy to tell you that I'm in the shop today...making ...a box. Oh, it's been a comedy of errors so far. The grain match on mine...well there will be none! Oops! That one little important part where the lid has to fit on that tennon of the body. I forgot to pay attention to that part and had to cut the darn tennon off twice! Thank goodness for pyrography tools :)

I'll be sure and post my misery.

Jen