Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Still sticky....

Posts

Still sticky....

#1

Still sticky....

Ed Wujciak

>I've always used wipe-on poly to finish turnings and have had no problems. I've been reading here about using lacquer and decided to try some. Put 2 coats of minwax lacquer on a birch turning and it looked kinda dull so I decided to put some poly over it. Mistake. Waited overnight and the poly is still very sticky. I assume I've inadvertantly violated a cardinal rule but I don't know what it is. Do I wait? Will it dry? Must I remove it? Educate me please....

Re: Still sticky....

#2

Re: Still sticky....

Ron in Drums PA

>Two good source for an education

"Great Wood Finishes" by Jeff Jewitt

"Finishing Secrets" with Russ Fairfield Video

Re: Still sticky....

#3

Re: Still sticky....

bowlman

>Ok, so you are in a pickle. Will it dry ... probably not. Will it remain sticky, .... my bet is yes. So what to do? If you decide to try removing the sticky poly, see below ... but remember, its a secret!

Try wiping it with my super secret ingredient ... WD40.

Re: Still sticky....

#4

Re: Still sticky....

Bill Stehman

>Hi Ed,

I too have run into this from time to time and feel I didn't let the lacquer dry long enough. If it isn't to sticky you can try applying another coat of 15% thinned poly on top or take lacquer thinner and clean off the old finish then start again. Both methods have worked for me and the first is less messy.

Re: Still sticky....

#5

Re: Still sticky....

Mike Nelson

>Ed, paint thinner should remove the poly and not effect the lacquer if it was dry.

Re: Still sticky....

#6

Re: Still sticky....

Ed Wujciak

>Thanks for the responses. I sorta thought of all of them, except the WD-40. The drying process is proceeding, but slowly. I'll give it a day or two, then decide. Thanks again.