Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Duck Watching

Posts

Duck Watching

#1

Duck Watching

Dennis Bilevich, Prescott, AZ

>Alligator Juniper Wood - 16" Wide 1 1/2" Tall. Used Turbo Carver II And Razor Tip Wood Burner. Finished with Deft 50/50 with lacquer thinner. Then Buffed. All comments welcome regarding the photo as I am still learning how to do this. Any comments on the wall hanging would also be appreciated.


img

Re: Duck Watching

#2

Re: Duck Watching

Bill Hale / Woodspinner

>JUST GREAT

Bill in Casa Grande

Re: Duck Watching

#3

Re: Duck Watching

gil jones

>Very well made!!

Dog looks great.

Re: Duck Watching

#4

Re: Duck Watching

C.W.Stivison

>IMPRESSIVE

CW

Re: Duck Watching

#5

Re: Duck Watching

Molly Winton

>That's just beautiful Dennis. What is the source of your design? My Dad would go nuts over something like this. Your burning is very well done with crisp edges and very good line definition. I'm assuming you had to get the burning pen pretty hot for a strong burn like this. Did you find the Razertip pen difficult to work with over time, due to the pen getting so hot? I primarily burn with the Burnmaster or DetailMaster using the DetailMaster pen for background burning. Mine has a rubber tubing to insulate, which works pretty well. My Razertip pens however, get almost too hot to handle at the temperature which I prefer to burn, and do so almost immediately.

Again, a very well executed piece. It's a keeper for sure.

Re: Duck Watching

#6

Re: Duck Watching

Jorge Castaneda

>Dennis,

Beautiful work, no comments about that, for the picture part you did very well too the only suggestion is to leave some air around the piece, it is a little crowded the way it is.

Thanks for showing!

Jorge

Re: Duck Watching

#7

Re: Duck Watching

Dennis Bilevich, Prescott, AZ

>Thanks to everyone for the nice comments. Molly, Yes the RAZERTIP does get hot on the #10 setting, but able to go approx 15mins per burn before getting to hot . The design was found on line in CLIP ARTS. Thanks a lot Dennis