Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

A few shop tips...

Posts

A few shop tips...

#1

A few shop tips...

Peter Teubel

>Nothing revolutionary, just a few ideas to share in hopes that some may find useful.

#1) It seems I'm always knocking over my friction polish bottle. Either hitting it with my arm or forgetting to move it when I blow off the lathe with the compressor. I squeezed one of those rare earth magnets in it and now it's a lot more stable.



#2) While the Oneway 1224 has a nice stand and there's room to place your tools under the bed, I tend to HIT the bed when putting them there, thus dulling the edge. Plus, when I lean over the bed to hollow, I tend to hit the tools over the other side. So I build a quick tray to hold a few tools. I also hinged it so it can fold down when not in use.




#3) I used to attach a velcro stip to the lathe to hold sand paper, but I found that it would clog with shavings and tend to peel off after awhile. So I took a piece of plywood, sanded it down to 600 (for better adhesion), and attached two velcro strips to it. In the back, I coutersunk two rare earth magnets. Now, the board can live on a vertical surface while I'm turning and when I get to sanding, it attaches to the bed securely...right where I need it.




Re: A few shop tips...

#2

Neat Tips Peter

Barbara Gill, Remlik VA

>

Re: A few shop tips...

#3

Barb Siddiqui

those Are useful...thank you!

Barb Siddiqui

>

Re: A few shop tips...

#4

Re: Well done, Peter. Thanks! :o)

Allen Neighbors

>

Re: A few shop tips...

#5

Re: A few shop tips...

tm

>I use the same finish... brilliant solution.

Thanks,

tm

Re: A few shop tips...

#6

Great tips, especially for us "newbies"

Pat Taylor

>

Re: A few shop tips...

#7

Time to order......

George Van

>Time for me to order some magnets Peter! Thank you for the ideas, I can think of a dozen uses as I type, maybe I had best get two dozen.

Re: A few shop tips...

#8

Re: A few shop tips...

john lucas

>Peter I thought I was the only one who stabbed thier freshly sharpened skew into the side of the lathe. I slide tools under my Nova mini all the time and always manage to stab at least one into the cast iron side.

Re: A few shop tips...

#9

Re: A few shop tips...

Carole Valentine

>I stabbed my gouge into one of the sandbags on the shelf under my lathe not long ago. Nothing pours out of a small hole as fast as fine, dry sand! I have also knocked enough tools off my lathe that I now have anti-fatigue mats on all sides. Saves a lot of grief since it is a known fact that any dropped tool will land on it's cutting edge.

Re: A few shop tips...

#10

I know the feeling...

Bob Fawcett

>several times I have done that little dance to get my toes out of the path of a falling cutting edge. So far I have outdanced the tools, but I won't be "dancing with the stars" anytime soon.