Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

Do you know "therming"?

Posts

Do you know "therming"?

#1

Do you know "therming"?

Barry Irby

>Another of my "inventions" stolen by the ancients. One of our club memebrs demonsrtated turning fish. The process is to put two blanks side by side and turn the profile, then interchange them and turn the same profile again. Then a little bandsawing and sanding and couple of quick passes with a fillet knife, a few minutes on the grill, and dinner is served.

He passed the pieces with the "square" ends still attached around the room and it dawned on me that if you stretched thme out long enough you could make balusters for a railing that were sort of two dimemtional and yet attractive (I invented that application right on the spot.). I pointed this out to a fellow club member who earns a buck or two turning balusters. Yes, says he, It's called Therming. My ignorance is so vast you could fill the Internet with it. That may be what the Internet is for, storing all the information I don't know.

Turns out the turner who demoed the technique to our club member turns 24 balsusters at a time. Has a drum he mounts on the lathe that holds them. He turns one side and then rotates them on the drum a 1/4 turn and repeats.

A variation on off Axis turning.

Pen turners take note. Just Googled therming and found an article that included imformation on turning 3 or 4 sided pens.

Just thought I would pass this along. Maybe there is another WC'er like me that does not know all there is to know about turning.

Re: Do you know "therming"?

#2

Re: Do you know "therming"? *LINK*

Mike Brazeau

>The link that Barry mentions is below. The fellow he refers to is in our guild and I wrote the article back in 2005. He has since developed a router sled technique and applied it to improve his cutting technique on the comples glue-ups he has of very exotic woods. If anyone wants to venture into Wikipedia, this is one word that is not in there. Have thought of writing it up, but never found the time. The image taken from Darlow's book of Woodturning Methods is almost the only other reference available.


img

Pen Therming article

Re: Do you know "therming"?

#3

Re:"therming"?

Mike Nelson

>That seems like a good idea but wouldn't there be a lot of tear out?

Re: Do you know "therming"?

#4

Only 24 times the tearout.

Barry Irby

>

Re: Do you know "therming"?

#5

24 catches instead of just one :)

john lucas

>

Re: Do you know "therming"?

#6

Re: Do you know "therming"?

Art Liestman

>Sigi Angerer demonstrated this technique at the 1998 AAW Symposium and his demo is included on that year's video. He also wrote an article about it which appears in the Summer 1998 American Woodturner. In fact, the cover of that issue features a picture of him demonstrating the technique. I've used the technique on some new pieces that I've been doing for the past few weeks.

Re: Do you know "therming"?

#7

Leo Van Der Loo

Probably the way thes where done 325 years ago 

Leo Van Der Loo

>


img