Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

How to turn a picture frame?

Posts

How to turn a picture frame?

#1

How to turn a picture frame?

Jim K in Trappe PA

>I have a clock face that I would lke to mount in a round frame. How do I mount it and take it off the chuck? I will be using 1" stock. I have several scenarios in my head, but none are very elegant!

Thanks,

Jim K

Re: How to turn a picture frame?

#2

Re: How to turn a picture frame?

Russ Babbitt

>I assume you will just be turning the face. Mount a piece mdf larger than you frame to a faceplate. Then take your frame and from the back of the mdf screw it in place. Making note of where your screws are turn the face of your frame. Make sense???

Re: How to turn a picture frame?

#3

Re: How to turn a picture frame?

Jim K in Trappe, PA

>Thanks, Russ. That was one of the scenarios in my head, but I was hoping for a super simple failsafe turning trick that I was overlooking.

The challenge is that I'll need to screw into the wood 1/2" to make sure it doesn't fly off, so I need to define my highpoints before I cut. I haven't thought out the dimensions, but it will require precision to make sure I don't hit a screw. Also, since i will need to turn the back before I turn the front, I'll need to align an already turned piece close to dead center on the MDF, which is do-able, but ripe for Murphy's law, based on how I make and transfer measurements!

Actually, the more I think about it, the more fun it sounds.

Re: How to turn a picture frame?

#4

Re: How to turn a picture frame?

Russ Babbitt

>I would think that if you draw a "bullseye" on the mdf you should be able to center the frame pretty good. You might be able to turn the back in the same manner before doing the front. Again you need to know where you design is beforehand. You might be able to use an adhesive instead of screws, but I have doubts as to the safety of that. OT> I made a round clock frame with plans from Woodsmith that used a router in a trammel point and different cutter profiles. I know that is not turning but it was round.

Re: How to turn a picture frame?

#5

Re: Industrial Strength...

Allen Neighbors

>hot glue will hold the frame to the MDF.

Re: How to turn a picture frame?

#6

Re: How to turn a picture frame?

Dennis Daudelin

>Another approach that I've used is to make the frame as a segmented ring and then mount it on a cole plate holding it on the outside of the ring. I then cut the recess for the picture and the inside of the frame. The next step is to mount the frame on the cole plate holding the center of the frame. Then cut the outside to your final dimension. It's a two-step process but it goes really quickly!

I hope that makes sense, it's a very safe and effective way to do this!!

Love to hear how you finally choose to do it and see some pictures!!

Dennis

Re: How to turn a picture frame?

#7

Re: How to turn a picture frame?

James Fox

>Good quality double stick tape should hold it to a piece of MDF screwed to your face plate. A light touch will be required.

James

Re: How to turn a picture frame?

#8

Re: How to turn a picture frame?

Jim K in Trappe PA

>Hi Dennis,

A few questions? What is the pint of segmented rings? Does it do something mechanically, or is it just to save wood?

As for curtting the center, do you have a backing board of any kind so you don't hit the cole jaws when you cut through?

Thanks,

Jim