Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Holly Vase

Posts

Holly Vase

#1

Holly Vase

Scott Hurley in N. VA

>The wood is holly that I got from my neighbor last summer. It had turned darker, so after I turned it, I bleached it. It's actually a little lighter than the picture shows. With such a light wood, I had fits getting the color balance correct. I'm not sure I got the form right (is it too fat in the middle?). The finish is 3 coats of water-based poly, then sanded w/ 600 grit to smooth out the raised grain, and Beal buffed.

Scott


img

Re: Holly Vase

#2

Re: Holly Vase

GaryG in MD

>Hi Scott,

Very pretty. It's got to be difficult keeping it so pristine. It's a nice-looking piece.

I don't think it's too fat in the middle. Being super picky, because you asked, there's a short flat spot about an inch above the bead -- for me that's what's making the form just a tiny bit "off". To eliminate that you could have 1) brought the bottom around a little quicker at that point (moving downward), but that would make the piece shorter. To keep the same height, you could have 2) (moving upward at that point) not reduced the diameter quite as quickly. To compensate for the resulting slightly "heavy" bottom which would result, you could have curved it in a bit more quickly (going upward)and thus lowered the height of the minimum diameter point slightly. It's very subtle, and we're only talking a millimeter or two, but it makes a difference to the unforgiving eyeball. Let me know if you understand what I'm trying to say.

Again, it's a very nice piece -- but we're always seeking "perfection". ...Gary

Re: Holly Vase

#3

Re: Holly Vase

Bill Hale / Woodspinner

>Looks great to me. Gary, I think the flat area you see may be due to the angle of the pic.

Bill in Casa Grande, AZ.

Re: Holly Vase

#4

Thanks for the comments

Scott Hurley in N. VA

>