Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

OUCH!

Posts

OUCH!

#1

OUCH!

Barry Turner

>I was turning the ouside of a 9" Elm bowl today. I started to power sand and my cordless drill quickly ran out of steam. Not wanting to stop turning for the day, I decided to remove the Elm blank and rough another. I locked the headtock spindle and began to unscrew the blank from the Wood Worm screw held in my Super Nova 2 chuck. The blank suddenly came loose. I fumbled for it and the somewhat heavy blank came down hard on the first joint of the middle finger of my left hand, banging it against the heavy lathe bed. I lost my grip again and the blank continued it's fall downward and bounced along the floor of my shop. Sh*t! I watched as the joint of my finger began to turn a dark shade of blue and begin to throb and swell slightly! Lesson? If you drop a blank larger than an ornament.......just let it go!

Re: OUCH!

#2

JL

Re: And get your feet out of the way!

JL

>DAMHIKT. My sympathy. I know it hurts.

Re: OUCH!

#3

Re: OUCH!

john lucas

>Barry I learned that lesson a long time ago. And then again about every other year. I guess it's in my genes to catch things.

Re: OUCH!

#4

Impossible!

George Van

>

Re: OUCH!

#5

Re: OUCH!

Scott Hurley in N. VA

>Been there, done that. I feel your pain... Except for me it was my left index finger. Don't know if I cracked it or not, but it was sore for weeks!

Scott

Re: OUCH!

#6

Don't try catching....

Dave Belser

>Sharp things either! Just last night I changed the bit on my router table and was reinstalling the router motor underneath. The motor slipped and I tried to stop it, the spiral up cut bit did a nice job up-cutting my ring finger!#*!! Usually I'm pretty good at avoiding sharp falling things - I'm sure a lot of folks have the failing gouge dance move down pat (stay in the air until the gouge hits the floor). It just didn't occur to me that the router motor would be sharp - it's a motor.

- Dave

Re: OUCH!

#7

Thanks!

Barry Turner

>Sympathy is so hard to get these days!

Re: OUCH!

#8

At Least The Motor Wasn't Running.......

Barry Turner

>