Re: Which pen finish to use?
ScottS
>I typically use CA glue and Myland's Friction Polish. I typically sand to 600 grit on the lathe. Then I apply a thin layer of CA, especially if using a burl or other "punky" wood. Then I start at 600 grit again and sand to 2000 grit, still on the lathe. A single coat of Myland's Friction Polish tops things off. I think the finish left by the Myland's is better than Hut Crystal Coat, which I've also tried. I've also tried PPP and been disappointed. Multiple coats of Myland's doesn't seem to work as well as a single coat, FYI.
For acetate pen blanks, I sand to 2000 grit on the lathe, then polish with Novus #2, followed by Novus #1 both done off the lathe.
Both of these finishes are very quick and seem reasonably durable.