Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Responce to faceplate thread from Wed.

Posts

Responce to faceplate thread from Wed.

#1

Don Pencil

Responce to faceplate thread from Wed.

Don Pencil

>Fellow Turners.

Read the information below knowing that I am the manufacturer of the faceplates and therefore I have a "dog in this fight". None the less, I hope that the information is helpful.

There is a 1 1/4" x 8 tpi x 3 1/2" dia. aluminum faceplate on the back of the piece in this picture. They work very well. There is no need for a fillet (although it wouldn't hurt anything)on the inside of the faceplate. They just do not flex.

The 6061-T6511 aluminum last a very long time. Thousands of them sold over the last few years and now have wornout or failed that I am aware of.

Don Pencil

Manufacturer of Don Pencil True Turn Faceplates

WWW.DONPENCIL.COM


img

Re: Responce to faceplate thread from Wed.

#2

Re: Responce to faceplate thread from Wed.

tm

>I have used my 1x8 tpi- 2 inch Don Pencil faceplates on bowl blanks of various sizes for over 2 years. I always wondered what the safe

maximum capacity rating was.

No complaints from me.

tm

Re: Responce to faceplate thread from Wed.

#3

Don Pencil

Re: Responce to faceplate thread from Wed.

Don Pencil

>I personally go with the following.

2" up to 8" max. dia. (depending on depth

2.5" up to 10" max. dia. (depending on depth)

3" up to 14" max. dia. (depending on depth)

3.5" up to 18" max. dia. (depending on depth)

I might go bigger on the diameter, but it would be for a platter.

Deep bowls require smaller max. dia.

Heavy, dense woods require smaller max. dia.

Lighter, weight less dense woods can be bigger in dia.

In other words, you got a big chuck of wood on there, use caution, error on the conservative side.

As my dear old dad like to tell me, "use your head for something besides a hat rack." I,m still working on that ;)

Be Well,

Don