Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Tulipwood Vessel

Posts

Tulipwood Vessel

#1

Tulipwood Vessel

Neal Addy

>Tulipwood and Blackwood. 6-1/2" x 4-3/4". Sanded to 800, buffed, and finished with Seal-A-Cell.

Each of the seven components were turned individually and then assembled. Joints were done with tenons and CA.

The piece will be presented as a birthday gift to MIL.


img

Re: Tulipwood Vessel

#2

Re: Tulipwood Vessel *LINK*

joaz

>Stunning! Really a beautiful piece. You should be very proud.


http://www.maine-web.com/woodturning

Re: Tulipwood Vessel

#3

Brad Vietje

Re: Tulipwood Vessel

Brad Vietje

>Here, Here ! Real nice piece -- hollow, too ? Nice shapes and nice looking finish, too. Your M-I-L is a lucky woman.

Safe spinning,

Brad Vietje

Newbury, VT

Re: Tulipwood Vessel

#4

Keith Tompkins

Re: Tulipwood Vessel

Keith Tompkins

>Beautiful job...this may be the best gift a MIL ever received! Did you form tenons on all the components?

Re: Tulipwood Vessel

#5

Re: Tulipwood Vessel

Neal Addy

>Thanks! Yes, there is a good sturdy tenon on each piece of Blackwood (roughly a 1/4"x1/4") that is set into the Tulipwood beads. The bowl has a 3/4"x1/16" foot that acts as a tenon for the base joint.

The bowls walls are about 1/8" so it is fairly light. It should hold up well if not mishandled.

Re: Tulipwood Vessel

#6

Re: Tulipwood Vessel

David Galloway

>Interesting form. The tulipwood is gorgeous. How did you do the cross on top....carved, but how?

Great job.

Re: Tulipwood Vessel

#7

Re: Tulipwood Vessel

David Galloway

>After looking at this again and again, my sense of humor could not resist for a gift for a MIL. Is this suggestive of a funeral urn?

Sorry, thinking of my own MIL. Next Christmas........

Re: Tulipwood Vessel

#8

Re: Tulipwood Vessel

gil jones

>Gorgeous, Neal!!

Re: Tulipwood Vessel

#9

Re: Tulipwood Vessel

Neal_Addy

>Hi David. The cross was turned as a thin (flat) bead and then carved with a Dremel using an engraving bit. You can't tell from the pic but it was also textured to look like timber.

Re: Tulipwood Vessel

#10

Very Fine!

Jorge Castaneda

>I like it a lot, everything is just right

Keep them coming, and thanks for sharing.

Jorge

Re: Tulipwood Vessel

#11

Re: Absolutely very fine!

Allen Neighbors

>