Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

PM 3520A Remote Switch Questions

Posts

PM 3520A Remote Switch Questions

#1

PM 3520A Remote Switch Questions

Clem Wixted, Jonesboro, AR

>I am about to hook up a home brew remote on/off switch for my 3520A lathe.

First question is the routing of the wire from the head stock to the switch. I am thinking of routing it along the back side of the ways, around the end and below the tail stock and to the switch.

How is the factory switch wiring routed and how long is it?

What type of wire do they use? I am planning on using SJ 2-wire, 16 gauge.

Thanks,

Clem

Re: PM 3520A Remote Switch Questions

#2

Re: PM 3520A Remote Switch Questions

john lucas

>Clem The factory doesn't route the wire. The switch has a magnetic back so you can put it anywhere. I'd guess the cable is about 8 feet or so. It runs through the back of the headdstock where the main input wires go. I don't know the gauge I'd have to check.

Re: PM 3520A Remote Switch Questions

#3

Thanks, John

Clem Wixted, Jonesboro, AR

>I think I can take it from what you have given me.

If I can find my digital camera I will take some pictures of the steps in putting this awitch together.

I am using ideas from a numer of sources and even a few of my own.

Clem