Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Teardrop scrapers

Posts

Teardrop scrapers

#1

Teardrop scrapers

Don O.

>I was sharpening the cutting bits on my new hollowing setup last night. After reading the instructions (yes I actually read the instructions)I had no problems grinding a nice edge on the cutters. My question is about the teardrop shaped scrapers. The instructions showed pix of grinding the curved edge all around but not the straight side. Do you all grind the straight edge also, and maybe use it for other than hollow vessels ? I'm curious what others do. I can see the straight side being used as a shear scraper on the outside of a bowl, maybe.

Thanks for any insight here, Don

Re: Teardrop scrapers

#2

Re: Teardrop scrapers

tek-Brunswick, Ohio

>Yes, if the tear drop scraper has the hole in the center. Some have a slot for the screw on the straight side. You may not have the clearence to use the straight side if the screw and shaft are too close to straight side. I use the straight edge of the Sorby tear drop from the Multitip tool to shear scrape on the outside bowls and especially the flat inside of platters.

Re: Teardrop scrapers

#3

Re: Teardrop scrapers

Russ Babbitt Jr.

>Since they are my scrapers I grind them any way I please. Depends on how I use the edges.

Re: Teardrop scrapers

#4

Re: Teardrop scrapers

joaz

>If you just hone them, they last a lot longer.

Re: Teardrop scrapers

#5

Re: Teardrop scrapers

Don O.

>Thanks for the responses folks.

Russ, you have a good point there (palm slaps forehead here).