Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Question for those that engrave their names *LINK*

Posts

Question for those that engrave their names *LINK*

#1

Question for those that engrave their names *LINK*

Ron in Drums PA

>What do you use to fill in the engraving?

I tried some colored touch up sticks on some scrap and wasn't to happy.

I remembered someone using a big gold crayon. Is this any good and where is it sold?

TIA


Wood Turning Exchange 2007

Re: Question for those that engrave their names *LINK*

#2

Re: Question for those that engrave their names

john lucas

>Ron I use a product called Rub-n-buff. It's sold at the craft stores like Michaels and Hobby Lobby. You can get it in several different golds, as well as copper and silver. It's a very fine wax and is easy to rub in. Mineral spirits will take it off. I try to put a layer of finish on before I engrave because the wax will fill in any pores as well and it's really hard to get out of the pores.

Re: Question for those that engrave their names *LINK*

#3

Re: Question for those that engrave their names

Dennis Yoder

>Cindy Drozda sells the big gold crayon. Dennis

Re: Question for those that engrave their names *LINK*

#4

Re: Question for those that engrave their names

Brian Hahn in SW Wisconsin

>I sign with the engraver before finishing, so it is only filled with the finish. I've never felt the need to fill even on dark woods.

Re: Question for those that engrave their names *LINK*

#5

Dick Hines

Re: Question for those that engrave their names

Dick Hines

>I only engrave on dark woods that a fine atrist pen will not show up on. I put a coat of finish no the bottom ,let it dry then engrave. Then I use a silver marker to fill in where I engraved. Let the marker dry for 30-60 min and sand off the excess.

Re: Question for those that engrave their names *LINK*

#6

I use the BurnMaster on all, works good.

gil jones

>

Re: Question for those that engrave their names *LINK*

#7

Re: I use the BurnMaster on all, works good.

John Lucas

>Gil How does the burnmaster work on woods line Wenge, ebony,blackwood and ebonized wood. I'm curious because I've never tried it.

Re: Question for those that engrave their names *LINK*

#8

Re: I use the BurnMaster on all, works good.

gil jones

>John, if you are asking how it works on dark wood, well it works fine, but is harder to read due to not enough contrast.

If you are asking about how it works on "HARD" woods, well, I have never owned a piece of that exotic stuff so I do not know. On Oak and hard burls it does fine, but I need to crank up the heat a little.

I am very pleased with the BurnMaster (Eagle), and I use the DetailMaster (hardwired) handsets (#6A for signing work).

Gil