Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Delta Lathe Question

Posts

Delta Lathe Question

#1

Delta Lathe Question

Lester Gillett/Independence Mo

>I have the Delta 14/40 lathe and the spindle threws at too long.

I got a Nova Midi chuck for Christmas but when i thred it on the

jaw slides hit the spindle be for it bottoms out on the shoulder.

I tried useing a platic washer but it still hits be for tighing

up on the washer, Has any one had this proublem? I am going to

call Delta repair center and see what they say. Do you think i can

put a nut on the spindle and cut some of it off then clean up the

end? Don't want to mess it up so will see what any one says or

Delta befor doing any thing.

Lester

Re: Delta Lathe Question

#2

Re: Delta Lathe Question

Chuck Engstrom

>Hi Lester -- I suspect you'd be better off to take a Dremel or such and grind out the first female threads in the chuck's adapter. It shouldn't take much. This way you'll still end up with the adapter's rear face tight against the face of the spindle for best alignment. I've done it on my Midi to sit properly over the shoulder on my spindle.

Best--

Chuck Engstrom

Re: Delta Lathe Question

#3

Re: Delta Lathe Question

Lan Brady

>Lester,

It is a 1" spindle. Use one or 2 metal washers from the hardware store.

I am sure someone can give reason not too, but it has worked without incident for me.

Good Luck, Lan

Re: Delta Lathe Question

#4

Re: Delta Lathe Question

john lucas

>Lester I had the same problem with a few faceplates and one chuck on my Powermatic. I installed 2 of the nylon washers and it's taken care of the problem. Vicmarc has created new inserts for thier chucks that are deeper and solve this problem. I've picked up one of those but still use the double washer for one of my chucks. It seems to work just fine.

I also turned one out of metal that's a hair thicker than the double nylon washers. It's for one of my faceplates. This one seems to work well also.

Re: Delta Lathe Question

#5

Re: Delta Lathe Question

Lester Gillett/Independence Mo

>Thanks guys for the help. The Delta repair guy called me and said

he is going to have a 1/4" thick washer made for me to use as a

spacer. I didn't want to cut the end off and then have to clean up the theads so this washer should do the trick. My 3" face plates

we had to cut the bottoms out so they would seat on the rear face.

Not sure why Delta would make the threaded end so long and then not

make face plates or chucks to fit right. Hope to be useing my chuck

by the week end as i have some unfinished turning to do and i need

the chuck to do that.

Lester

Re: Delta Lathe Question

#6

Re: Delta Lathe Question

john lucas

>I don't know about Delta but the newer powermatic lathes extended the threads and put a flat area so you can lock the faceplates on to allow you to turn in reverse. Unfortunately older faceplates and chuck inserts are too short for this longer length.

Re: Delta Lathe Question

#7

Re: Delta Lathe Question

bob davis

>i use a washer cut fron 1/8 tempered masonite