Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

A new near miss....

Posts

A new near miss....

#1

A new near miss....

ChuckS

>I had a bit of a scare today while making Christmas presents. I was using my little Jet mini, which is sitting an a huge work table. I set my skew down on the table & it rolled off the edge. I am AFRAID of the edge of the skew. It's SHARP & pointy. I was able to grab the handle of said skew, whew- that will save a bunch of sharpening/honing time. Then I realized I was wearing sandels. The skew would have landed pointy end down on my poor little toesies! DUMB. Very, very dumb.

Lessons learned again:

1. Never wear sandels in the shop.

2. I need to build a tool rack or put an edge on my table.

Look ma, I have ten toes!

ChuckS

Re: A new near miss....

#2

Re: A new near miss....

Doug Thompson near Cleveland

>I'm glad your safe. Don't ever grab the sharp end...let it fall DAMHIK

Re: A new near miss....

#3

Re: A new near miss....

eliot d

>It's real easy to make one of those horizontal tool holders with the zig-zag , v-shaped, ridges along two edges. I've seen it here somewhere. But it's more or less obvious what to do.

Re: A new near miss....

#4

Re: A new near miss....

Brian Hahn in SW Wisconsin

>One of my shop rules is to always wear leather shoes. I learned that one the hard way many years ago.

Re: A new near miss....

#5

Re: A new near miss....

Bob Fawcett

>I usually wear leather shoes, but I bet a skew that is sharp would go right through.

I would recommend steel toes. This may be overkill, but I dropped a crankshaft on my foot in 1974. I still have a lump at the "knuckle" of my big toe on the right foot. I would rather have a skew with a dulled point than a skew point in my foot. Better yet, make a holder of some kind and use it.

Re: A new near miss....

#6

Re: A new near miss....

Mark Wollschlager

>Another thing I have seen, but not tried, is to flatten a part of the handle with a belt sander.

Keeps the tool from rolling as easily.

Mark.