Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Upgraded to VS now a couple questions

Posts

Upgraded to VS now a couple questions

#1

Upgraded to VS now a couple questions

Stuart Johnson

>I've upgraded my Nova 3K to VS and have a couple questions.

1. What is the best way to mount the frequency converter? I'm thinking the TS end is best but I'm at a loss as to how.

2. What is best pulley set up to use? The Nova has 8 speeds arrangements. I don't usually turn anything real heavy or large and rarely turn over 2000 rpm.

Re: Upgraded to VS now a couple questions

#2

Steven Antonucci

I've consider it too...

steve antonucci

>Can you send me an e-mail regarding what you needed to buy and how long it took?

santonucci at aol.com

Steve

Re: Upgraded to VS now a couple questions

#3

Re: Upgraded to VS -warning long reply *LINK*

Bruce Wiseman

>I looked at mounting mine on the lathe stand under the head stock side in a small plastic box, but I worried about heat build up. In the end I mounted it on the wall right above and behind the headstock. I made a small control box with the on/off, speed control, etc and glued a couple of rare earth mags on that so that I can place it any where on the lathe that I want. I got all the parts from radio shack and it cost around $20 - $30 to make.

As for speed I mostly run with the belt in the 1440 position. scribe a circle around he center point of your speed pot. Mark the low end or max counter clockwise position. Turn the pot up until the HZ display reads 10, mark that and do the same for 20, 30, etc. When you have that 10 will be approx 260 rpm, 20 = 523, 30 = 788, 40 = 1050, 50 = 1320, and 60 = 1580. But I mostly go by feel and never worry about the rpm number.

All this comes from an excellent web site by a very helpful guy named Ken. Follow the link to turning and then look for the upgrade Nova 3000 it will take you through the whole thing.


http://www.theturnersshop.com/

Re: Upgraded to VS now a couple questions

#4

Re: Upgraded to VS -warning long reply

Stuart Johnson

>Thanks Bruce. Having just done the same thing only I went with the 2HP motor I understood everything he wrote. Steve, if you see this be sure and follow the link. He has laid out the whole thing step by step.

I'm still not sure where I'll mount the controller but it will probably be somewhere near the tail stock. I'm not against a wall so I can't mount it there.

Re: Upgraded to VS now a couple questions

#5

Brad Vietje

Re: Upgraded to VS now a couple questions

Brad Vietje

>Stuart,

I did this about 2 years ago for a club lathe -- couldn't mount the controller on the wall since it had to be portable. Made a wooden box that triples as stand, storage box and transport "casket". We mounted the controller next to headstock at first, then inside the box below the headstock, if I remember correctly.

No need to worry about belt position -- you now have the best of both worlds -- variable speed over 8 different ranges. You'll want a lower range for roughing green bowls from out of balance stock, and a higher range for spindles or buffing -- just move belt as needed.

Safe spinning,

Brad Vietje

Newbury, VT