Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Finishing" busy " wood

Posts

Finishing" busy " wood

#1

Finishing" busy " wood

eliot d

>I just hollowed two vessels in plum wood. It was a pleasure to turn them green. But I would say that the surface has a very "busy" look. By this I mean it has all sorts of little lines, dots, grey swirls, additional grain markings. All kinds of stuff. I know that sometimes this sort of thing can look fine. But I can tell you that in this case, it's just kind of ugly. I tried finishing with some oil, which just made it worse, in my opinion -- it added an overall blotchy yellowish hue that didn't do anything for it.

I'm sure others on this site have experience something similar. Do you have any ideas. I worked fairly hard to hollow these out.

Re: Finishing" busy " wood

#2

Brad Vietje

Re: Finishing" busy " wood

Brad Vietje

>Hey Eliot,

Any way you could post a picture ? I usually like a lot of interesting figure in the wood, but sometimes that only works with very simple shapes -- too much detail competes with the highly figured wood.

Safe spinning,

Brad Vietje

Newbury, VT

Re: Finishing" busy " wood

#3

Re: Finishing" busy " wood

George Van

>Hi Elliot, I find that a seal coat of lacquer or shellac helps a lot to eliminate the blotchy appearance of figured grain and spalted woods before applying an oil finish.