Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Rosand sanding sealer mix

Posts

Rosand sanding sealer mix

#1

Rosand sanding sealer mix

Dennis Taylor

>I recently attended a demo with Bob Rosand, and the mixture that he applies before taking his final cut is Sanding Sealer & turpentine, but oil based Sanding Sealer, I have looked at 2 of the box stores in my area, and they have lacquer based Sanding sealer, there is only one that don't say "lacquer" in it, that is made by Minwax, does anyone know if this is oil based?...the cut is 50/50, and I used a lacquer based sanding sealer now, and it gets gummy, several people have said the oil will not, just takes longer to dry as a seal coat, and then something applied over it...any input is appreciated...Dennis

Re: Rosand sanding sealer mix

#2

Re: Rosand sanding sealer mix

Pete Kekel - Kentucky

>When Bob did a demo for our club, I'm pretty sure he used Minwax Sanding Sealer and turpentine for his mix. That's the same mixture I started using and it works as advertised.

Re: Rosand sanding sealer mix

#3

Re: Rosand sanding sealer mix

georgetroy

>Go to your Sherwin Williams store. They will have the sanding sealer you are looking for. It comes in one gallon cans. Be sure to mix with oderless Turp. Works best in clear plastic container with a spout on it. Vol. about 1/2 quart or less. Use a funnel to mix. If you elect to later leave and let dry good, you can sand and use a Tung Oil finish over it. GT

Re: Rosand sanding sealer mix

#4

George is correct...

Ed Moore

>Bob told me that he uses Sherwin-Williams sanding sealer as described. He may use others besides S-W, I can't say.

Ed

Re: Rosand sanding sealer mix

#5

Re: Rosand sanding sealer mix

Juergen

>I bought the Minwax sealer last weekend. As you surmised it's oil based as clean up is with paint thinner or turpentine. Drying time is 2 hours. In using the product I found it to be very thick. The next time I will cut it 50/50 to improve the penetration.

Re: Rosand sanding sealer mix

#6

Re: George is correct...

Peter Toch

>Instead of all the speculation and heresay, I suggest you contact Bob Rosand directly and get his "secrect potion" from the source. Bob is a real nice guy and I'm sure he will be glad to discuss the compositions and techniques of the finishes he uses. His email address is: rrosand@rrosand.com, and phone: 570-784-6158 (from his website: www.rrosand.com).

Peter