Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

vicmarc vl100 break-in

Posts

vicmarc vl100 break-in

#1

vicmarc vl100 break-in

Phil in NJ

>Hi,

I just finished setting my new VL100. The spindle/headstock is fairly noisy, and some grease is migrating out of the bearings on the tailstock side.

I cleaned the pulleys, belts, etc. The motor running alone is quiet.

Can anyone comment on the break-in period for these lathes? Do they run more smoothly after a few hours?

Thanks

Phil

Re: vicmarc vl100 break-in

#2

Re: vicmarc vl100 break-in

Russ Babbitt Jr.

>I have two. One of the originals and one of the new larger size and I think they are great. The club also has one and I had to replace the bearings because of noise. After replacing them the grease did ooze out for a while and they do run warm. I am not sure why it is noiser than mine. I know of no break in necessary. Where did you buy it? Consider sending it back for replacement.