We value your privacy.
We use cookies to enhance your browsing experience, analyse site traffic, and personalise content.
By clicking “Accept all”, you consent to our use of cookies. You can also choose
“Essential only” or learn more.
I the motor for my Bealle finally but the dust and I will be using my lathe to buff and get through the season til I can replace it. What do I use to hold the buffs? I don't want to crush the threds on the buffs.
>My Beall system came with an adapter to fit a 1/2-in. motor shaft. I cut a short length of 1/2-in steel rod to hold the adapter and fits into the small jaws of my chuck. Gives me variable speed for the buffs.
>I picked up an accessory that fits the #2 morse taper of my headstock and it has a threaded hole on the end to accept the Beall buffing wheels. I believe it was an item offered by Beall, but I'm not positive. It does need to be well seated, or at least held in place through the head stock, because it does have a tendency to spin itself out if it isn't.
>I have exactly this set up, and , yes, the morse taper has a tendency to spin out of the spindle. what I do is to place a little hard rubber plumbing washer at the end of the threaded part and bring the pointed live center up and into it to put pressure against the headstock. It just can't spin out this way.
>I sounds like you have the same set up I have. You can thread a 1/4" bolt in the end. I use all thread through the headstock and a wing nut with a washer to hold it in place. It just needs to be snugged down to prevent the slipping.