Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Will Vicmac Jaws fit on a Supernova2? *LINK*

Posts

Will Vicmac Jaws fit on a Supernova2? *LINK*

#1

Will Vicmac Jaws fit on a Supernova2? *LINK*

Ron in Drums PA

>Will Vicmac Jaws fit on a Supernova2 chuck?

TIA


Here is what I'm looking at to buy

Re: Will Vicmac Jaws fit on a Supernova2? *LINK*

#2

Re: Will Vicmac Jaws fit on a Supernova2?

Mkauder, Phenix City, AL

>No. I have an old Teknatool chuck with tommy bars, a SuperNova and a SuperNova2. They will take Oneway Stronghold jaws though.

Mark

Re: Will Vicmac Jaws fit on a Supernova2? *LINK*

#3

Re: Will Vicmac Jaws fit on a Supernova2?

Bill Stehman

>Ron,

I wanted a set of those also and bought the grizz chuck and pin jaws. Tis no vic but works fine. Total was less than $100 a year ago.

http://www.grizzly.com/catalog/2006/Main/111

Re: Will Vicmac Jaws fit on a Supernova2? *LINK*

#4

Re: Will Vicmac Jaws fit on a Supernova2?

Ron in Drums PA

>Bummer!

Re: Will Vicmac Jaws fit on a Supernova2? *LINK*

#5

Re: Will Vicmac Jaws fit on a Supernova2?

Ron in Drums PA

>Thanks Bill

Grizzly is close, but they won't fit the bill.

Re: Will Vicmac Jaws fit on a Supernova2? *LINK*

#6

I don't think so...

Peter Teubel

>The Talon jaws are interchangable with the Nova line. Stronghold and Vicmarc jaws are not interchangable.

Re: Will Vicmac Jaws fit on a Supernova2? *LINK*

#7

Re: Will Vicmac Jaws fit on a Supernova2?

john lucas

>The grizzly chuck jaws fit the Vicmarc 3 1/2" chucks.

Re: Will Vicmac Jaws fit on a Supernova2? *LINK*

#8

Re: I don't think so...

Mkauder, Phenix City, AL

>Peter,

Thanks for correcting me.

Mark

Re: Will Vicmac Jaws fit on a Supernova2? *LINK*

#9

Yes, but it's a one way mod.

Phil Joines Krum, Tx

>The Griz jaws and interchangeable with the Vic. I modified a set of the Griz pin jaws to use on my Super Nova. The hole spacing is the same but they need to be drilled out to fit the larger screws (6mm?). I used a machinists bit but don't remember the size. Deepen the champher so the screw heads are flush. They also needed to have a few thousanths filed off the outside of the tennon.