Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Laser Hollowing Rig - Finally!

Posts

Laser Hollowing Rig - Finally!

#1

Laser Hollowing Rig - Finally!

Allen Neighbors

>Finally finished my Laser mount for my captured system. This pic shows the light mount before I cleaned it up and lacquered it.

The pen is from Radio Shack, and uses 2 AAA batteries.

I used a 1/2" pipe flange to mount a 1/2" pipe for the upright with a 1/2" Tee with set screw on top of that. Then a 3/8" pipe became the sliding, pen mounting arm. The pen mount is from Linden Wood.

I used it today, to hollow a Black Walnut form that is 8.5"tall X 4.5"dia. I hollowed it through a 5/8" opening, and got quite a bit of chatter going that deep with a 1/2" shaft, but the light didn't waver. It works! :o)


img

Re: Laser Hollowing Rig - Finally!

#2

Re: Laser Hollowing Rig - Finally!

Bob Fawcett

>Looks great Allen.

I was sure you made that pen mount. What kind of wood is Linden Wood, I never heard of it?

Re: Laser Hollowing Rig - Finally!

#3

Re: Laser Hollowing Rig - Finally!

Allen Neighbors

>Thanks, Bob. The pen mount looks a lot better now that it's finished and shaped better. :o))

Linden wood is another name for Basswood, I think. A retired judge, uses it to carve highly detailed skulls for forensics use. He gave me a couple of good sized chunks. It's very lightweight, and soft, but works perfectly for little jobs like this, where lighter is better. :o)