Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Nova 3K Motor Upgrade Problem

Posts

Nova 3K Motor Upgrade Problem

#1

Nova 3K Motor Upgrade Problem

Stuart Johnson

>I purchased a 2hp VS motor for my Nova 3K. As luck would have it I ordered it on Monday and it got here yesterday. Anyway other that not having a 220 circuit run yet I'm having a problem with the old motor. I can't get the motor pulley loose. I have taken out the set screw and verified it wasn't stacked on top of a second one. I have been able to drip some penetrating oil into the set screw hole but no joy yet.

Any suggestion on how to get the pulley off? I could get a bigger hammer but don't want to crack the cast iron motor mount plate.

Re: Nova 3K Motor Upgrade Problem

#2

Re: Nova 3K Motor Upgrade Problem

Darryl Hansen

>The pulley is keyed as you probably already know. I pulled a pully from a motor by putting a piece of 2x1/8 iron sheet into which I cut a notch about half way at the center point so it would slike over the shaft. Drilled two holes one at each end. Made another piece this time scrap angle iron. Drilled hole at both ends and one in the center. Ran two bolts through the end holes that matched the two in the backing piece. Put a bolt and matching nut in the center hole. Tightened the center bolt into its nut and that forced the pulley off the shaft. Probably now that you have put what I gues is "Liquid Wrench" on the shaft by the time you read this and make the puller it will probably fall off :<))

Re: Nova 3K Motor Upgrade Problem

#3

Re: Nova 3K Motor Upgrade Problem

Bruce Wiseman

>After a soaking with liquid wrench I used a couple of small wedges and drove them down between the pully and the motor wall. It came right off. I don't think a gear puller will have enough cleareance to get all the way down around the base of the pulley but if you know someone who has one it wouldn't hurt to check that out. Good luck.

Re: Nova 3K Motor Upgrade Problem

#4

Got it thanks.

Stuart Johnson

>I remembered I had a tool to separate ball joints. I few whacks and it started to move. At no point did it just slip on off but it did finally come loose.

Thanks for the help.