Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Help! Rescue Operation Needed!

Posts

Help! Rescue Operation Needed!

#1

Help! Rescue Operation Needed!

Jim Rutten

>Hello All,

I making Christmas presents. The main one was going to be a mahogany 8-10 inch bowl. I turned the outside and it looks great. Today I was going to start on the inside and I took it off my faceplate and was going to chuck the tenon. When I turned it on it was wobbly. Upon further investigation it appears this kiln dried (I assume) wood was left standing in water. The tenon just flaked off and the outside section of wood was rolly (great technical description, huh). I would hate to lose this peice at this stage in the game. Got any suggestions.

Re: Help! Rescue Operation Needed!

#2

Re: Help! Rescue Operation Needed!

gil jones

>I have used slightly thinned epoxy to firm up a punky piece. (West System Epoxy, slightly thinned with lacquer thinner) It seems to cure rather slowly (24 hours), but that fact allows plenty of soak time to give the wood time to absorb plenty of epoxy.

I have heard some folks say that DNA works to thin epoxy, but have not tried it.

Gil

Re: Help! Rescue Operation Needed!

#3

Re: Help! Rescue Operation Needed!

Doug Trembath

>Well, Jim, welcome to woodturning!

About all I can suggest is to put it back on the faceplate and turn a new tenon and make a shallower bowl. Make darn sure you turn back to solid wood though, and if you can't, hello firewood.

As we progress through this journey we all find some disappointment, but the rewards, in the long run at least, seem to outweigh the bummer pieces of wood. There's always the next one!

Doug Trembath

Studio in the Woods

Re: Help! Rescue Operation Needed!

#4

Re: Help! Rescue Operation Needed!

Bill Hale / Woodspinner

>My thought is it starts bad and it very likley will end bad. If you bought the wood take it back. If it is found wood no big deal.

ALTERNATE. Soak in a hardening solution of choise and start over. You still have the mounting holes, just remount to the plate and turn a new tennmon. After you turn a new tennon I would run some thin CA around the base of the tennon and do a light reclean.

Good turning and be safe

Bill in Casa Grande, AZ.

Re: Help! Rescue Operation Needed!

#5

Re: Help! Rescue Operation Needed!

Jim Rutten

>Thanks, Gil, Bill, and Doug!

Re: Help! Rescue Operation Needed!

#6

Steven Antonucci

Turn off the bad tenon and add a glue block

steve antonucci

>then turn the tenon on the glue block.

QED

Steve

Re: Help! Rescue Operation Needed!

#7

Re: Turn off the bad tenon and add a glue block *LINK*

Darrell Feltmate

>I am with Steve on this one since I do not use a tenon anyway. Hot glue on a glue block and go for it. If the base wood is too punky for it, first use a thin CA to harden the wood and then use a glue block. CA is expensive for a whole bowl but for some punky wood on the base, not bad.


Around the Woods