Ellis, howsabout an update on your yew?
Thad
>
Knowledge You Can Build On — Est. 1998
Ellis, howsabout an update on your yew?
Thad
>
Still working on it
Ellis Walentine
>I have gotten about 8" into the hollowform, through a 1 1/8" hole, but I am worried about going deeper without some sort of hollowing rig that will resist the catches at this depth. I've never freehand turned any deeper than this and I'm nervous. One tiny catch at that depth would blow the top of the pot to bits. I do like the shape, but I think that rather than try to hollow any deeper, I might just shorten the pot by about 4".
The reason this piece is still on the lathe after five weeks is that I've been really busy dealing with our elderly moms, selling the family house, doctors, hospitals, and way too much else. Hopefully I will get a chance to finish the piece before it gets ruined by mold and blue stain. We'll see. Life doesn't get any less complicated around the holidays. :-)
What would you do?
Ellis


WOW
Brad Vietje
>Ellis, that's going to be fantastic! If I was making the decisions, I'd probably prefer to keep the lovely profile you have, and give up the hollow form idea, converting it to a flared out vase. May not be at all what you are after, but it sure would be a great looker ! I have a hard time seeing how a shorter profile would look as good, but maybe you really want the extreme hollow form challange more than the lines of the outer profile.
Please keep us updated, and best of luck with all your burdens.
Safe spinning,
Brad Vietje
Newbury, VT
Re: WOW
Thad
>I agree with keeping the profile. I don't know if it fits into the "magic ratio," but I would be afraid of it looking "squatty" if it were shortened.(But the plus side of making it shorter would be that you could use the bottom half for another turning)
I would also hate to loose the figure in the top of this piece too though, so I would do what you've done...wait until I can come across a hollowing system to get all the way into it...or maybe part the top off (carefully) then hollow it out and then glue the top back on (and not tell anybody.)
Thanks for keeping us posted. Hopefully you can save it all.
~ Thad
Decisions
Ellis Walentine
>I happened to be having dinner at David Ellsworth's house last night and told him about my quandary. He had loaned me his big Thompson tool a few years ago and I was nervous about using it for this because I had had some catches with it in similar vessels in the past and I really don't want to screw this one up.
Anyhow, he told me the secret is to turn the tip so it is at least 45� to the shank -- no straighter -- and keep the cutting edge at the center line, and that will ensure that the tool only twists harmlessly out of the way instead of getting caught. Easy for him to say.
I'll let you know how I make out. I might be doing some more turning tonight. Might be.
Cheers,
Ellis
Re: Decisions
David Galloway
>Ellis, Beautiful piece. I hope you will post your results. I do not like the feeling of "anticipating" a catch, thus screwing up the investment of time and energy. I remember turning a 26" diameter cherry salad bowl for my sister in law. I was a nervous wreck until I was finished.
I only wish I could "drop by" David's. I spent a week with him last winter and was so taken by his hospitality and teaching skills.
Again, hope you will show what you did.
Re: What would I do??
Russ Fairfield
>Buy the hollowing rig.
Better yet that you can borrow one.
Even better that you borrowed it from Ellsworth because it is already trained, and that should make it easier to use.